Saturday, July 30, 2011

Using Reference Points Nº 2




I decided to add wax to the right side of the front of the lower torso, rather than subtract wax from the left side. So first I placed the cue ball in the socket, then added small balls of wax to build-up to where it's needed.






Then I remove the cue ball, and use the calipers again to check the measurements. Then I use the paring knife to trim the excess off.



This isn't something that is done just once. As I model the lower torso, I may need to check this again and again, and make needed adjustments. As one part is changed, it may affect another part.




Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.