Sunday, March 18, 2012

03 Armature Nº 19




I drilled the hole in the back of the lower torso and inserted the back iron. This is the front view.






This is the side view. I have tried to get the figure in the middle of the modeling board.



I still have a few fine adjustments to do, then I will cut the four-stranded wire the same lengths as the two-stranded wire. All the holes will be drilled slightly larger to fit the four-strand wire. Then I will make the wooden armature pieces for the arms and legs.

I have an "L" bend for the foot, but I may cut that off and replace it with wooden feet that have a hole drilled in them for the wire armature. That way, I can remove the feet easily for modeling, or at least for molding. I am still trying to think of ways to make this a reusable armature. I still do not know if it will work, but I am going to try.




Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.