Wednesday, March 21, 2012

03 Armature Nº 22




I took the armature apart, drilled all the holes out to 3/16 inch, cut the four-strand armature wire, put all the wooden parts on the four-strand armature wire, and put the armature back together again. This is the front view. Click on any image to enlarge it.






This is the side view. The feet have been drilled with a small hole, and a wire brad nail is holding them to the modeling board. The wire brads should pull out very easily when it is time to take the figure off of the modeling stand.



The next thing I am going to do is coat all the wooden parts with shellac.




Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.