Saturday, March 24, 2012

04 Modeling Nº 2

I use a ceramic clay wire tool to cut a two pound block of Prima Plastilina into smaller chunks that can be warmed up quickly and easily handled.

I lined a cardboard box with some aluminum foil on the bottom and placed the cut chunks of oil-clay on the foil.

I place a couple of small pieces of scrap wood across the top of the box to hold the incandescent light bulb.

This is the 75W incandescent light bulb in a clamp-on light fixture.

This is the oil-clay warmer box in action. A light bulb is a better source of heat than light, so this setup works just fine.

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.