Tuesday, November 20, 2012

08 Joint Design Nº 13




I drilled holes in the bottom of the legs. First I drilled a 1/4 inch pilot hole, then I drilled a larger 3/8 inch hole, and finally, a 1/2 inch hole. I did the same thing on both legs. Click on any image to enlarge it.






This is my drill bit with a pair of vise grip pliers clamped on it. The pliers made it easier to twist the drill bit into the leg.






These are the tops of the legs, which I have carved out with my paring knife.



It looks like I may have to do some symmetry work on the legs.




Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.