Monday, December 31, 2012

08 Joint Design Nº 54




On the left is the bottom of the cast carving wax head, showing where the spare was located. On the right is the original head, modeled in oil-clay, showing the wooden armature inside the head. There is a recess where the wire armature of the neck on the torso fit. Click on any image to enlarge it.






Here I have marked the depth that the neck fit into the head, using some masking tape.






The depth is about 17mm. This is where the top of the neck ball needs to go. I am thinking of making the neck similar to the way that Ryo Yoshida made the neck on the doll in his book.






Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.