Saturday, February 16, 2013

08 Joint Design Nº 101






As I work on the torso joint, I stop and fit it together from time to time. Click on any image to enlarge it.






I trim the inside edge of the upper torso.






I use my wax pen to fill in where I added a piece of carving wax too the bottom front edge of the upper torso (upper half of photo below). Then I use my paring knife to subtract the excess filling (lower half of photo below).






Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.