Tuesday, March 26, 2013

08 Joint Design Nº 139




I use thumbtacks to pin the matte board ring to the carving wax ring. Then I use my paring knife to trim the I.D. of the carving wax ring even with the inside diameter of the matte board ring. I simply remove one thumbtack at a time when I come to it, so I can trim under the head of the thumbtack, then I replace it. Click on any image to enlarge it.






Now both of the legs are at about the right height, measured against my working drawing.






Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.