Thursday, March 28, 2013

08 Joint Design Nº 141




I positioned the 70mm matte board rings on the lower torso's hip sockets. Then I used my wax pen to add carving wax, where needed, and my paring knife to subtract carving wax where needed. Click on any image to enlarge it.






I used a pair of dividers and triangulation to position the matte board rings on the lower torso.






I used a hole cutter to cut a hole in the hip joint ball.






The hole is nice and clean.






I used my paring knife to cut off the excess carving wax, leaving both hip joint balls with a flat bottom that sits on a table very nicely.






Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.