Saturday, April 6, 2013

08 Joint Design Nº 150




I did the layout for the left hip socket on the lower torso, then scribed a line, 70mm in diameter. Click on any image to enlarge it.






I used my wax pen to make the first cut, a few millimeters inside the scribed line.






I used my paring knife to trim the carving wax out to the 70mm diameter  line. Here, both 70mm matte board circles are inserted in the hip socket holes.






This is a turn-around of the torso sitting on the hip balls in the hip sockets.






Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.