Friday, April 26, 2013

08 Joint Design Nº 170




I continue working on the hole in the top of the lower carving wax leg. I use my paring knife and the carving tool. Click on any image to enlarge it.






As I work, I check the size of the hole with a 40mm diameter ping ping ball. If I twist the ping pong ball back and forth in the hole, it rubs a spot inside the leg that shows me where I need to trim some more.






Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.