Tuesday, June 4, 2013

08 Joint Design Nº 209




I drilled a hole through the wrist into the lower right carving wax arm. It was a long hole, measuring just under two inches before the drill bit broke through into the arm cavity. I also drilled a starter hole in the right carving wax hand. Click on any image to enlarge it.






I looked for, and found some small balls to see if they might work for the wrist ball joints. I found two marbles and a hard rubber ball. The small marble is 15mm, the hard rubber ball is 22mm, and the large marble is 24mm. So far, I like the hard rubber ball the best.






Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.