Wednesday, July 3, 2013

08 Joint Design Nº 235




Since the neck ball is 40mm in diameter, I use a ping-pong ball to close the socket hole in the head. I fasten it in place with some masking tape. Click on any image to enlarge it.






I melt some carving wax in my wax pot.






After pouring the wax into the head, through the hole I drilled, I let the carving wax solidify, then I cool it down with some cold water. This is the freshly cast socket.






Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.