Saturday, July 6, 2013

08 Joint Design Nº 238




I am going to fill the hole in the head that I made in order to pour the neck socket. I am using a carving wax spare from one of the cast balls as a filler plug. Click on any image to enlarge it.






I use my paring knife to carve the spare into a cylinder that fits snug in the hole.






I heat up the wax pen and put the filler plug in the hole.






I work around the filler plug with the wax pen, trying to weld the head to the filler plug. Then I cut the excess off with the knife, and make sure everything is welded.






I use my paring knife to trim the carving wax filler plug down to the surface of the head.






Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.