Thursday, July 11, 2013

08 Joint Design Nº 243

Just as I was getting setup to cast the hip sockets by pouring carving into the lower torso, I remembered a better way of making sockets for a large joint like these. It is the same way I made the socket in the upper torso, for the lower torso to fit in. So I stopped what I was doing, turned everything off, and I will attempt to do this tomorrow. Click on the image to enlarge it.

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.