Saturday, July 13, 2013

08 Joint Design Nº 245

I used a wooden dowel, inserted through the hole in the top of the lower torso, to knock out the hip sockets. Click on any image to enlarge it.

I have started working on the hip sockets. The hip balls must go into the hip socket at least 40% of their diameter. I may end up pouring some molten carving wax around them, from the top, when I get them into position, in order to hold them in place.

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.