Sunday, September 1, 2013

08 Joint Design Nº 295




Today I drilled a hole and cut the slot in the right carving wax hip ball joint. I use the V-gouge and the X-Acto knife to cut the slot. Click on any image to enlarge it.






After I cut through the slot, I clean it all up with my paring knife.






I cut this slot a little bit more than the first slot. I am sneaking up on it.






The right leg has a little bit more range of motion than the left leg.






Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.