Wednesday, September 11, 2013

08 Joint Design Nº 305




Today I unstrung the left carving wax leg and drilled a hole and cut a slot in the ball joint of the lower leg. Click on any image to enlarge it.






While I had the lef unstrung, I also drilled a hole and cut a slot in the upper leg ball joint. This was the first slot I made, and it was shorter than the one I made in the right leg, so this evened them up.






I restrung the leg and played with it for awhile, trying to figure out what I need to do.






Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.