Thursday, September 12, 2013

08 Joint Design Nº 306

I drilled a hole in the ball joint of the right lower carving wax leg. Click on any image to enlarge it.

I used the X-Acto knife to cut the slot.

Flexing the right knee.

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.

No comments:

Post a Comment

This is my personal BJD making journal. All comments are moderated. If you make a new comment under an old post, your comment will be published under the old post. I reserve the right to publish or delete any comments made, at my own discretion. Thank you for looking.