Thursday, September 10, 2015
09 Plaster Production Molds Nº 297
I did a little more scraping of this mold piece. There is this one place where the arm transitions to the ball joint that I think I'm going to have to carve out a little bit. I'm thinking about it. An alternative to carving the plaster would be to put a small piece of oil clay in there. If I did that, it would be something that I would have to trim once the part is slip cast. I'm leaning towards carving the plaster. Click on the image to enlarge it.
Links To BJD Tutorials Updated 1 August 2015
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.